USP Compact

The first USP Compact models appeared in 1994. These are scaled-down USPs, and are available in all the same cartridges as the full size version, and additionally the .357 SIG. Due to the smaller size of the frame, magazines for the Compact variant may have a handgrip extension to better accommodate the shooter's hand. Standard flat floorplates are also available for the USP Compact magazines. The USP Compact comes standard with a bobbed hammer equipped with a flat rubber external thumb grip. This reduces possible snag from the hammer on a holster or clothing while the pistol is being drawn, but still allows the USP Compact to be cocked from a decocked position even in the absence of a spurred hammer. This can be done since decocking the weapon does not fully drop the hammer, leaving it in a somewhat "half-cocked" state. However, the USP Compact cannot be cocked from a dry-fired position as the hammer will be flush to the back of the slide, although the operator could pull the trigger approximately halfway back in a dry-fired position to put the hammer in a half-cocked state, allowing the hammer to be fully cocked with the thumb. A spurred hammer, similar to the one that comes standard on the P10 can be installed onto the USP Compact. USP Compact models lack the mechanical recoil reduction system of the larger full sized USP pistols. Instead, a more compact recoil buffering system is composed of a polymer bushing, around the captive recoil spring, which is designed to absorb energy at the end of the slide's travel rearward. This polymer bushing, with an estimated lifespan of around 20,000 rounds, is used instead of the double spring/captive recoil spring/guide rod found in the full sized USP.